You
can make your own earring wires with copper wire, colored wire,
sterling or gold.
1. Just cut a piece of wire the length of the EZ
Earring tool. Place
it in the jig next to the pin.
2. Bend the wire to the right a bit with your finger. Place the spinner thingy on the pin. The spinner thing
will make the loop for you. If your wire is facing 3:00, the knob on
the spinner will be at 12:00
3. Turn the spinner thingy clockwise.
4. Voila'! The loop is done!
5. Then press the smaller lever.
6. Bend the wire around so you can squeeze the next lever.
7. Squeeze the bigger lever and you've just made an ear wire. for
best results, keep pressing the small lever with your left thumb while
you press the big lever with your left hand.
8. Trim the ear wire and you're ready to decorate your
earrings! For uniform earwires, keep the ear wire in the jig, holding the big
lever with your left hand. Using your right hand, trim the excess wire
flush with the edge of the tool.
If you like the shorter shank of a simple
shepherd hook earring, you
can skip the first step 1 to 4 of making the loop. After bending the ear wire
with the first and second levers, just form your loop where you want
it using a round nose pliers.
For a custom look, skip the first steps 1 to 4 of making the loop so that you can add a crystal, stone or pearl.
Then finish off the loop
manually with a round nose pliers. And add your matching dangle!
Wire Sampler Pack
Get enough wire to make 5 pairs of earrings for only $1.00
Choose up to 5 colors, and I'll cut enough wire for you to make 5
pairs of earrings.
Choose from any color wire shown in my 20 g. jump ring
pages.
Wire
Colors:
Black Aqua Purple Green
Red Blue
Magenta Teal
Topaz Burgundy
Kelly Green
Antique Gold Amber
Christmas Green
Lilac
Peach
Silver
Pink Lavender
Tangerine
Sea Foam
Lemon Baby Blue
Amethyst
Gold
Fuchsia
Olivine Pacific Blue
Flag Blue
Off White
Peacock
Blue
Bare Copper,
Tarnish Resistant Copper
Choose the first wire color:
Choose the second color:
Choose the third color:
Choose the fourth color:
Choose the fifth color:
Select “1" for the quantity. Come back to this page if you want another sampler pack: Qty:
Earring Tip!
To smooth out the ends of your ear wires, you have two
choices:
1. Use an emery board; you know, the nail file that's spongy in the
middle.
Rub it over the wire with a few swipes and check to see if
it's smooth yet.
It might take 8 or 10 swipes to smooth it.
- or -
2. Buy the "Round Your Wire" tool. Round Your Wire Round Your Wire
This Tool has a cupped tip.
The inside of the cup is a file to smooth
the ends of your ear wires.
Useful with any wire that you've cut
when you want to smooth it.
This is a handy tool to have when
you make your own ear wires with the EZ Earring.
To speed up the process, insert the wood handle into the chuck of a
cordless drill.
$7.00
Qty:
This tool only makes a simple shepherd
hook earring. It's fun to use and fast.
But it doesn't have the option of adding a bead to the shank. Easy Ear Wire
$25.95
Qty:
Jump Ring Color Chart
35 different colors!
In addition to a rainbow of colored jump rings, the chart includes copper and tarnish resistant copper.
$5.00
